2012 Norland Freedom Series 3000 Blow Mold System


• Blow Molder; Freedom Series 3000, 208/220V, 3ph, 60hz
• Air Compressor: (6) 15hp, 208V, 3ph, 60hz
• Chiller: 100,000 BTU, 208/220V, 3ph, 60hz
• Air Dryer & Filter: 317 CFM, 580 PSI, 220V, 1ph, 60hz
• Air Tank: 250 gal, 480 PSI ASME Certified, Verticle
• Elevating Conveyor: 12ft, 115V, 60hz
• Mold: 500ml, 4 Cavity
• Mold: 600ml, 4 Cavity
• Mold: 1L, 4 Cavity
• Mold: 1.5L, 4 Cavity
• Pre Forms: $15K in Inventory
System is rated up to 3000 bph.

Used Norland Freedom Series 3000 Blow Mold
Installed New In 2008
General System SpecificationsProduction Rate: Up to 3000 500ml bottles per hour
system includes,compressor, air dryer, mold chiller, molds and spares kits
Bottle Size:
   Min: 125ml
   Max: Up to 2.0L (confirm bottle dimensions with Norland International)
Power Requirements:  220 3-phase 60hz (Recommended Service- 125amp)380 3-phase 50hz (Recommended Service- 80amp)
Pre-form Specification (not including flange thickness or total thread length - measured up to flange)
 Min Length: 2.7" (68.6mm)
 Max Length: 4.6" (116.8mm)
 Min Diameter: .6" (15mm)
 Max Diameter: 1.02" (26mm)
 Max Inside Diameter: .55" (14mm)
 Min Thread Diameter: .94"  (24mm)
 Max Thread Diameter: 1.25" (32mm)
 Max Flange Diameter: 1.34" (34mm) (other sizes available on request)
 Max Flange Thickness: .13" (3.3mm)
Compressed Air Requirements: Air Pressure: 450 PSI (3.1mPa)
CFM:127 cfm – (3.8 cubic meters per hour)
Air Line Hook Up Size: 1” FPT
Quality: Oil Free, Clean, and Dry
Includes molds for 355ml, 500ml, and 600ml


2007 SIPA SFL-4, S/N 1564
    INLINE 2 STAGE MOLDER,  4  CAVITY, 440V/141 KW, CAP. (500 ML 7200/HR.)
       CURRENTLY SETUP FOR PRODUCING 28PCO  1810 NECK BOTTLES 

We have a 4 Cavity Mold Available for this Water Bottle

Mold is for a Norland Freedom Series 

​Blow Molding